Canon Pixma Pro-a hundred Setup Printer Connection Guide
If you latterly bought Canon pixma Pro-100 and want to start printing immediately however don't have any clue how to set it up then we are here to help you and you have not anything to worry about.
Ways to setup Canon Pixma Pro-100
There are specially three approaches that you can attempt to use to canon pixma pro-100 wireless setup. They are-
WPS Connection Method
Network Settings Confirmation
Standard USB Connection Method
We could be explaining them under and you may pick the method which suits you the satisfactory.
Canon Pixma Pro-100 setup thru WPS Connection Method
Before putting in place Canon Pro-a hundred using WPS Connection Method, you need to maintain the subsequent factors in mind-
Ensure that the get right of entry to factor has a bodily WPS transfer.
You can seek advice from the usual connection technique if there may be no WPS switch
Make certain that your community is the use of WPA or WPA2 security protocol due to the fact a lot of WPS supported get right of entry to factors use it
Refer to the subsequent steps for Canon Pixma Pro-one hundred setup via WPS Connection Method:
Switch for your Canon Pro-one hundred printer
Press and maintain the Wi-Fi button positioned on top of the printer till you notice a blue light
Once the blue light glints, make certain that it goes up the indicator. As quickly as it reaches the get admission to factor, press the WPS button within 2 mins
The Wi-Fi light will hold flashing at the same time as it will look for a connection.
This is an indication that Canon Pro-one hundred has been connected successfully
Canon Pixma Pro-one hundred setup via Network Settings Confirmation
Turn on canon pixma pro-100 wireless setup
Load in a letter sized simple paper or A4 sheet
You will see a sign which says Resume/Cancel. Press and keep it till the light sparkles for at the least 6 times
Once you launch it, you'll get a print out of the network page
Make sure that you have an energetic connection at the same time as referring to the published page. Ensure that the Service Set Identifier is displaying the actual name of your wireless community.